Application Instructions
Initial Preparation: Pre-remove loose dirt and dust with a vacuum cleaner, broom, or mop. Follow the general and specific work safety standards for each product. Shake the material well.Solvent: Water.Application
Renovation and Maintenance CleaningMix approximately 50-100ml of Parkett Soap in 10 liters of water in a suitable container.Slightly moisten the floor using a suitable mop. Avoid excessive use of water and long application times to prevent swelling of wood and cork floors.Regular polishing should be done with a single-disc rotary machine equipped with the special white LOBA pad or manually with the LOBA hand pad to increase the durability of the conservation film.Intensive Cleaning
Mix Parkett Soap with water in a 1:2 ratio.Slightly moisten the surface with a sprayer or mop.Immediately treat the surface with a single-disc rotary machine equipped with the special green LOBA pad.Vacuum the dirty water with a wet vacuum or absorb it with cloths or mop, then clean with clean water.On large surfaces, proceed in sections to avoid wood swelling, using only the necessary material and limiting the application time to the minimum required.After this procedure, treat the floor with LOBA ParkettOil Deluxe or the originally applied sealing oil, after complete drying.General Guidelines
- Tool Cleaning: After use, clean the tools with water.
- Application Conditions: The information contained in this document and in all other customer notes and recommendations result from practical experience and refer to standard application conditions. Due to the wide range of application and usage forms and conditions, the applicator may use their own experiences or obtain technical instructions through contact with the LOBA technical department. Recommendations from floor manufacturers and current standards must be respected. Our responsibility is limited to the content of our General Commercial Conditions, not expanded by this information or the advice of our after-sales technical service. The emergence of a new recommendation or technical standard automatically invalidates those previously in effect.
- Drying Time: The indicated drying times are valid for 20°C and 50% relative air humidity, with good ventilation of the work areas, free of drafts. Lower temperatures, higher relative air humidity, and poor ventilation cause delays in the indicated drying period. Before the complete cure of the product, do not place protective covering, do not clean with a damp cloth, and do not place rugs. If you have to cover the surface before complete curing, use LOBA Cover 400. Specific product indications can be found in the respective technical data sheets.